Delta T Marine Brush Application Instructions
Brushing Instructions
Equipment Needed:
- Paint brush – no more than 4”
- Water source
- Small container to hold water
- Rags
- Drop Cloth
- Masking Tape
Directions for Brush Application:
- Mix product as per regular instructions on pail.
- Prep surface as you normally would with conventional brushing application.
- Brush product as you would brush most any other paint system. Try to brush in one direction and in methodical fashion. Excessive stroking will only remove product from substrate back to brush. Build up an 8-15 mil (0.25-0.40mm) later and let it dry to touch. This coating should show initial brush strokes. The strokes will disappear as the coating begins to dry. It will self level by itself to some degree.
- If desired, the coating can be sanded to give a really smooth appearance. Just build up the coating a little more than needed and sand smooth with 220 grit sandpaper. Try not to sand very much, as you are taking away insulating power.
- Clean brush and tools with water.